Functional Description - Bosch PFZ 500 E Bedienungsanleitung

OBJ_BUCH-2 609 000 792-001.book Page 3 Tuesday, February 7, 2006 9:59 AM

Functional Description

Read all safety warnings and all
instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fire and/or serious injury.
Intended Use
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on the
workpiece. It is suitable for straight cuts. The saw blade
recommendations must be observed.
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Saw blade*
2 Guide stop
3 Hand guard
4 On/Off switch
5 Lock-off button for On/Off switch
6 Soft grip
7 SDS saw blade receptacle
8 Slider for SDS saw blade release
*Not all of the accessories illustrated or described are
included as standard delivery.
Technical Data
All purpose saw
Article number
Rated power input
Stroke rate at no load n
0
Tool holder
Stroke rate control
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
– in plastic
(max. pipe diameter)
Weight according
to EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific coun-
tries, these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
2 609 000 792 • 7.2.06
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 88 dB(A); sound power level
99 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
The typically weighted acceleration is 5.5 m/s
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
PFZ 500 E
Engineering
3 603 C98 0..
W 500
spm 0–2700
SDS
Robert Bosch GmbH, Power Tools Division
mm 23
mm 150
mm 10
mm 150
kg 2.0
/II
English–3
The vibration emission level given in
WARNING
this information sheet has been meas-
provisions of the directives
Dr. Eckerhard Strötgen
Head of Product
Certification
2
.
89/336/EEC,