Cleaning And Maintenance - Sata Satagraph 3 Betriebsanleitung

Operating Instructions SATAgraph 3
4.5 Nozzle set replacement (without tool)
The nozzle set consists of needle cap (4), air cap (5), paint nozzle with „O" ring
(6) and paint needle (7). For dismantling the nozzle set turn back sufficiently
the paint flow control screw (12). After screwing off the end piece (11) from the
gun body (2) and loosening the paint needle quick tightening (10), the paint
needle (7) can be pulled from the gun body (2) towards the back. The paint
needle (6) is removed from the gun body (2) after screwing off the needle cap
(4) and the air cap (5).
Pleas note:
The paint nozzle (6) is inserted only loosely into the air cap (5) - danger of
damage by dropping.
Assembly in the opposite sense:
After tightening the air cap (5) and the needle cap (4), the paint needle (7) is
carefully pushed into the gun body (2) towards the paint needle (5) at the front
until bedstop and fixed by tightening the paint needle quick tightening (10). Do
neither cant the paint nozzle (6) nor damage paint needle tip.
Attention:
Danger of hurting at the needle tip, especially if the needle cap is screwed off.
When foreign parts are integrated the quality level may decline and the
SATA warranty expires.
Nozzle sets:
134643 0,15 for SATAgraph 3 (without marking)
134650 0,25 for SATAgraph 3 (1 groove on paint needle, paint nozzle/air cap)
134668 0,45 for SATAgraph 3 (3 grooves on paint needle, paint nozzle/air cap)
134676 0,65 for SATAgraph 3 (4 grooves on paint needle, paint nozzle/air cap)

5. Cleaning and Maintenance

Never use force. Using improper tools such as pipe wrench, gas torch, etc. will void any warranty.
In many cases proper repairs can only be carried out with the aid of special tools. In such cases,
limit yourself to establishing the cause of the problem and leave the repairs to the service depart-
ment. We refuse to accept liability for perfect functioning of the spray gun if it is disassembled by
the customer.
a) Clean airbrush paint spray gun during every color change.
b) Flush paint spray gun with water, airbrush cleaner or corresponding solvent. With
paints and lacquers having a high pigment content paint and lacquer remainders
quickly deposit on the needle and around the needle cap.
c) After finishing the work, thorough cleaning of the parts in contact with lacquer and
paint is required.
d) If possible, the integrated air piston unit (8) should not be dismantled.
Occasionally grease lever mechanism and needle in the area of the lever
mechanism with a thin layer of silicone-free gun grease (Order No. 48173).
Do not grease the needle tip and the area of air cap and paint nozzle!
II.4
12
11
11
2
10
7
5
4