Maintenance - Makita 6310 B Betriebsanleitung

Switch action (Fig. 5)
CAUTION:
Before plugging in the machine, always check to see
the switch trigger actuates properly and returns to the
''OFF'' position when released .
To start the machine, simply pull the trigger. Machine
speed is increased by increasing pressure on the
trigger. Release the trigger to stop. For continuous
operation, pull the trigger and then push in the lock
button. To stop the machine from the locked position,
pull the trigger fully, then release it. A speed control
screw is provided so that maximum machine speed
can be limited (variable). Turn the speed control
screw clockwise for higher speed, and counterclock-
wise for lower speed.
Reversing switch action (Fig. 6)
CAUTION:
• Always check the direction of rotation before drilling.
• Use the reversing switch only after the machine
comes to a complete stop. Changing the direction of
rotation before the machine stop may damage the
machine.
This machine has a reversing switch to change the
direction of rotation. Move the reversing switch lever
to the ''FWD'' position for clockwise rotation or the
''REV'' position for counterclockwise rotation.
Speed change (Fig. 7)
To change the machine speed, turn the speed change
knob so that the reference arrow on the machine body
points to the desired speed indication.
CAUTION:
Turn the speed change knob only after the machine
comes to a complete stop.
Drilling operation
• Drilling in wood
When drilling in wood, the best results are obtained
with wood drills equipped with a guide screw. The
guide screw makes drilling easier by pulling the bit
into the workpiece.
• Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a center-punch and ham-
mer at the point to be drilled. Place the point of the
bit in the indentation and start drilling.
Use a cutting lubricant when drilling metals. The
exceptions are iron and brass which should be
drilled dry.
4
CAUTION:
• Pressing excessively on the machine will not speed
up the drilling. In fact, this excessive pressure will
only serve to damage the tip of your bit, decrease
the machine performance and shorten the service
life of the machine.
• There is a tremendous force exerted on the
machine/bit at the time of hole breakthrough. Hold
the machine firmly and exert care when the bit
begins to break through the workpiece.
• A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back
out. However, the machine may back out abruptly if
you do not hold it firmly.
• Always secure small workpieces in a vise or similar
hold-down device.

MAINTENANCE

CAUTION:
Always be sure that the machine is switched off and
unplugged before carrying out any work on the
machine.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
Makita Authorized Service Center.
GUARANTEE
We guarantee Makita machines in accordance with
statutory/country-specific regulations. Damage attrib-
utable to normal wear and tear, overload or improper
handling will be excluded from the guarantee. In case
of complaint, please send the machine, undismantled,
with the enclosed GUARANTEE CERTIFICATE, to
your dealer or the Makita Service Center.