AL-KO RANGER Betriebsanleitung Seite 46

en
CAUTION!
Danger of accident from uncontrolled manoeuvring!
As you are unable to see the side of your caravan that is facing away from you while manoeuvring,
the help of a second person is required.
During operation, ensure an adequately safe distance to people and objects.
Ensure a neutral stabiliser position.
The operator must maintain a minimum distance of 0.5 m from the caravan when manoeuvring it.
Also check the side of the caravan facing away from you.
If required, seek the assistance of other people to be on the safe side.
During operation, do not reach in between the drive rollers and the wheel - risk of crushing!
The manoeuvring system must only be operated by persons of majority age.
There should be nobody in the caravan while it is being manoeuvred.
Do not use the manoeuvring system
to manoeuvre or turn on public roads.
under the influence of alcohol, drugs or medication.
Upward or downward slopes represent a particular danger:
Note the maximum permissible incline.
Keep your distance from the caravan.
Always align the drawbar downwards.
Avoid coupling up and uncoupling the caravan on a slope.
When driving over steps and chocks, the drawbar can suddenly move vertically.
CAUTION!
Ensure that you have read the safety instructions carefully and follow the directions they contain!
CAUTION!
Check that the supply battery on the manoeuvring tool is fully charged and OK.
CAUTION!
Check that the caravan is uncoupled from the vehicle and that the handbrake has been applied.
Ensure that the levelling steadies (corner steadies) are fully retracted and secured.
1. Plug the end of the crank (6) into the hexagon (Fig. 6) on the right-hand or left-hand motor unit. This
is only required on one side of your caravan, since the other side follows automatically thanks to the
drive rod.
2. Turn the handle until you feel resistance. The colour of the pressure indicator (Fig. 5A) should now be
in the green area and an arrow pointing towards the wheel is visible.
3. Switch the battery disconnection switch on (28).
4. Before using the manoeuvring tool, release the handbrake.
5. Activate the manoeuvring tool by moving the sliding switch on the remote control (Fig. 9A) to the posi-
tion "I". The green LED (Fig. 9C) on the remote control lights up and a brief signal sound is heard. The
remote control is now ready for operation.
6. You can now control the movements in accordance with the symbols on the remote control:
46 695264_a