AL-KO RANGER Betriebsanleitung Seite 40

en
7. Switch the remote control on by moving the slider switch to the "ON" position (Fig. 9 A). The green
LED on the remote control now flashes slowly.
8. Press the RESET button on the control unit (Fig. 11 A). All three LEDs (Fig. 11 B, 11 C and 11 D) on
the control unit now flash slowly.
9. Simultaneously press the FORWARDS button (Fig. 9 B) and BACKWARDS button (Fig. 9 F) for at
least 3 seconds. The buzzer on the remote control will then indicate with a short sound that the syn-
chronisation step is complete. Following successful synchronisation, the green LEDs on the control
unit (Fig. 11 B) and remote control (Fig. 9 C) light up permanently.
10.Repeat this process with the second control unit.
11. Now switch the remote control off and back on again.
Installation of the manoeuvring system for tandem trailers is now complete. For further details regarding
operation, use, LEDs and the functions of the buttons, read the corresponding chapters in this manual.
40 695264_a