AL-KO RANGER Betriebsanleitung Seite 43

CAUTION!
Danger from accidental operation!
Secure the remote control against operation by unauthorised persons.
Do not place any objects on the remote control.
Protect the remote control against moisture and dirt.
Fig. Designation
9A Main switch (slider switch)
9B Caravan forwards
9C Green LED
9D Caravan forwards to the left
9E Caravan backwards to the left
9F Caravan backwards
9G Blue battery voltage LED
9H Red overload LED
9I Blue battery LED
9J Caravan backwards to the right
9K Caravan forwards to the right
During the forwards or backwards movement of the caravan (hold down button B or F), you can also correct
the movements by also pressing button D or K (forwards) or button E or J (backwards).
'Right forwards' (K) and 'Left backwards' (E) or 'Left forwards' (D) and 'Right backwards' (J) can also be
pressed simultaneously to rotate the caravan around its own axis without moving it backwards or forwards
(this function is only possible with 'single axle' mode).
When switching from 'Forwards movement' to 'Backwards movement' (and vice versa) within 2 seconds, a
delay of 1 second occurs to protect the electronics and the motor.
CAUTION!
The sliding switch on the remote control (Fig. 9 A) is also used as an emergency STOP button!
The remote control switches off automatically:
• After around 3 minutes of non-use:
• After around 6 minutes with permanent
pressure on one of the buttons:
The green LED goes out but the remote control remains in standby mode, there is still standby current
consumption and the battery slowly discharges. Ensure that the remote control is switched off with the main
switch after use.
You can re-activate the remote control by switching the main switch off and on again within 1 second.
695264_a
Function
Remote control ("OFF" - O and "ON" - I)
Both wheels turn forwards
Displays the status of the remote control and manoeuvring tool
Right wheel turns forwards
Right wheel turns backwards
Both wheels turn backwards
The voltage of the caravan's battery is too low or too high.
Overload protection on the manoeuvring tool has been activated.
The 9V battery in the remote control is flat and needs to be replaced.
Left wheel turns backwards
Left wheel turns forwards
After around 2 minutes, the buzzer sounds 5 times;
after 3 minutes this is repeated and the system switches to
standby mode.
After around 5 minutes, the buzzer sounds 5 times;
after 6 minutes this is repeated and the system switches to
standby mode.
en
43