Changing The Aspect Ratio - JVC GM-V42PCE Bedienungsanleitung

Changing the Aspect Ratio

RM–C579 REMOTE CONTROL UNIT
OFF POWER
DISPLAY
INPUT SELECT
A
VIDEO
B
MUTING
MENU/EXIT
Precautions for using the screen mode switching function
• This Monitor features a screen mode switching (aspect ratio
change) function. If you select a mode different in aspect
ratio from software such as TV programs, the picture may
look different from original picture. Be aware of this point
when you are selecting a screen mode.
• If you select a wide screen mode while viewing
conventional video programs of the aspect ratio 4:3, some
portions (edges) of the original picture will be cut off, or
deformed. To enjoy the original picture as it is, select
"REGULAR" while viewing such programs.
• If you place the Monitor in a tea room, hotel, etc. for
business purposes or public viewing and modify the picture
by using the screen mode switching (aspect ratio change)
function, this could violate the copyright protected by the
copyright law, which requires your special attention.
• If you make the screen very bright and watch programs
selecting "REGULAR," for a long period of time, the
Monitor screen may happen to be burned in. If this occurs,
watching programs using a wide screen mode for a while
will reduce the burn-in gradually.
ON
ASPECT
ASPECT
COMPO.
/(RGB B)
RGB A
VOLUME
With this Monitor, you can select among three types of wide
screens (FULL, ZOOM, and PANORAMIC) in addition to the
REGULAR screen of conventional 4:3 aspect ratio.
Press ASPECT to select the screen size.
Each time you press the button, the screen size changes as
follows:
REGULAR
PANORAMIC
REGULAR: Displays at conventional 4:3 aspect ratio.
REGULAR size display is enlarged
FULL:
horizontally.
ZOOM: REGULAR size display is enlarged
vertically and horizontally at the same ratio.
REGULAR size display is enlarged
PANORAMIC:
horizontally to the extent that the picture
does not look abnormally.
Notes:
• When one of the following signals is being input, you
cannot select the aspect ratio you want.
I 1080/50i, 1080/60i, 1035/60i or 720/60p signal through the
COMPONENT/RGB B input terminals
You can only select FULL.
I When any signal other than RGB15K-60 and RGB15K-50
through the RGB A or COMPONENT/RGB B input terminals
You can select only REGULAR and FULL.
• The aspect ratio can also be changed on the Function
Selection Menu (page 21).
FULL
ZOOM
15