Before Installing This Product; To Prevent Damage; Connecting The System - Pioneer AVIC-X1BT Installationshandbuch

Connecting the System

Before installing this product

• This product is for vehicles with a 12-volt battery and negative earthing. Check the bat-
tery voltage of your vehicle before installation.
• To avoid shorts in the electrical sys-
tem, be sure to disconnect the (–)
battery cable before beginning
installation.

To prevent damage

• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.
• This product cannot be installed in a vehicle that does not have an ACC (accessory)
position on the ignition switch.
ACC position
• When the auto aerial function is used by connecting the blue lead to the vehicle
with the auto aerial function, either turning off the ignition switch or detaching
the front panel will retract the auto aerial of the vehicle.
• To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especial-
ly important to insulate all unused speaker leads, which if left uncovered may cause a
short circuit.
• Attach the connectors of the same colour to the corresponding coloured port, i.e., blue
connector to the blue port, black to black, etc.
• Refer to the owner's manual for details on connecting the power amp and other units,
then make connections accordingly.
• When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse
holder.
• Since a unique BPTL circuit is employed, do not directly earth the ≠ side of the speaker
lead or connect the ≠ sides of the speaker leads together. Be sure to connect the ≠ side
of the speaker lead to the ≠ side of the speaker lead on the display unit.
• If the RCA pin jack on this product will not be used, do not remove the caps attached to
the end of the connector.
• Never connect speakers with an output rating of less than 50 W channel or impedance
outside of the 4 ohms to 8 ohms specifications to your navigation system. Connecting
speakers with output and/or impedance values other than those noted here may result in
the speakers catching fire, emitting smoke, or becoming damaged.
5
No ACC position