Din Rear-Mount; Fixing The Front Panel - Pioneer AVIC-X1BT Installationshandbuch

DIN Rear-mount

Installation using the screw holes on the
side of the display unit
• Fastening the display unit to the
factory radio-mounting bracket.
Select a position where the screw holes
of the bracket and the screw holes of
the display unit become aligned (are
fitted), and tighten the screws at 2
places on each side. Use any of screws
(4 × 3 mm), binding screws (5 × 6
mm) or flush surface screws (5 × 6
mm), depending on the shape of the
screw holes in the bracket.
*1 Use screws (4 × 3 mm) only.
Display unit
* 1
* 1
• When installing in a shallow space,
use the following screw holes. In
this case, stick conceal tape on parts
that protrude from the dashboard.
* 1
* 1
Conceal tape
Display unit
Factory radio mounting
bracket

Fixing the front panel

If you do not operate the removing and
attaching the front panel function, use
the supplied fixing screws to fix the
front panel to the display unit.
• Fix the front panel to the display
unit using the fixing screws after
removing the frame.
Fixing screw
Binding screw
(5 × 6mm)
Dashboard or
Console
Fixing screw
Front panel
26