Preparing The Hydrogen Station For Operation - Conrad H-racer Benutzerhandbuch

TIP: If you are under the age of 14, it is recommended you ask an adult for help for the following steps:
7C
Hold the fully-assembled chassis in your hand
and turn it upside down to find 4 small holes near
the edges of the chassis and near the 4 wheels.
Align the holes on the chassis with the holes on
the car top body (see 7C).
Step 8 Applying the "H " sticker on the front hood of the car body
2
8A
Position the car on a flat surface, with the front
of the car facing you. Remove the sticker from
its backing and position it according to the
picture (see 8A).
27
7D
Use a screwdriver (not included) to attach the
body to the chassis using the set of 4 small
screws (part H), and make sure the screws are
entered straight into the chassis. Do not tighten
the screws until all screws are partially entered
into the chassis. Drive the screws into the chassis
until no gaps are left between the body and the
chassis. Ask an adult to help fasten the screws as
this requires some force. To ease this process,
you can add a tiny amount of petroleum jelly (not
included) inside the screw mounts.
8B
There should be about 1 mm between
each side of the sticker and the blue
stripes on the car body, and the
sticker should be placed in the center
of the front hood (see 8B).
The assembly of your
The car is now ready to be fueled with hydrogen!

3. Preparing the Hydrogen Station for operation

3. Preparing the Hydrogen Station for operation
This refueling station can produce tiny quantities of hydrogen on your command, either by using
electricity generated by a solar panel (standard solar cell power source included), or 2 AA alkaline
batteries (not included). If you are using the solar panel, you must place it in direct sunlight for optimal
results.
For night time operation or during cloudy weather, the refueling station can also use 2 AA alkaline
batteries. Placing these batteries inside the refueling station is recommended even if you are only
using power generated from the solar panel. This enables you to switch from solar "☼" to "DC" power
at any time during refueling, or to accelerate refueling in case of a sudden change in weather.
Taking care of your Hydrogen Station:
Hydrogen Station
Do not use the for more than 20 minutes at a time. Once refueling of the
H-racer Hydrogen Station
is complete, turn the
Warning:
Continuous operation of the Hydrogen Station will damage it permanently.
H-racer
is now completed.
off and let it rest for at least 10 minutes.
28