Conrad H-racer Benutzerhandbuch Seite 14

Step 1
Place the chassis (part A) on a flat surface. Position the fuel cell (part E) onto the square slot located
in the middle of the car chassis behind the black motor - with the two nozzles on the fuel cell (part E)
facing upward and the red jack of the fuel cell located below the blue gears of the motor (see 1A).
As you position the fuel cell (part E), tilt the fuel cell so that the back of the fuel cell touches the
chassis and the front of the fuel cell is positioned slightly upward, above the small ledge behind the
motor (see 1A). Look underneath the chassis to make sure the bolts on the fuel cell are inside the
bottom ledge of the square opening in the chassis (see 1B). Now firmly push the front of the fuel cell
into the chassis, until you hear a click (see1C).
Step 2
Connect one of the flexible tubes (part G) to the nozzle located on the input valve (part D) (see 2A & 2B).
TIP: To fit the flexible tubes onto the nozzles, connect the tube by twisting it against the nozzle, then push the
nozzle into the tube until the tube is fitted snuggly to the base of the nozzle.
2C
Connect the other end of this flexible tube to the nozzle closest to the red jack of the fuel cell (part E)
(see 2C & 2D). Make sure the tube is inserted all the way to the base of the nozzle of the fuel cell
and the refueling input valve. The input valve and the fuel cell should now be connected together by
one of the flexible tubes (see 2D).
23
2D
Step 3
3A
Place the refueling input valve (part D) above the opening in the side of the chassis (see 3A). Slide
the refueling input valve (part D) into its mount, located at the opening on the side of the chassis
(see 3B). Make sure that the small ridges on the outer edge of the input valve (part D) are positioned
at the sides. With a downward motion, click the valve into place ensuring it is smoothly aligned with
the outer surface of the chassis.
Step 4
4A
Connect the second flexible tube (part G) to the nozzle located on the lid of the hydrogen storage
cylinder (part C) (See 4A & 4B).
4C
Connect the other end of the tube on to the fuel cell nozzle closest to the black jack (See 4C).
3B
4B
24