Werbung
Filtskiver og -spids: Slibebånd og -skiver
Fig. 5
Materiale
Træ
Stål
Aluminium,messing
Plastic
Børster af rustfrit stål og børster, der ikke er af metal
Fig. 6
Materiale
Sten, skal
Aluminium,messing
Fræsebit, graverspids og bor
Fig. 7
Materiale
Træ
Stål
Aluminium,messing
Plastic
Fræsning
Fig. 8
DK
Materiale
Stål
Aluminium,messing
Plastic
5. VEDLIGEHOLDELSE
Sørg for at maskinen ikke står under strøm, når der udføres vedligeholdelse-
sarbejder på mekanikken.
Maskinerne er udviklet til at fungere længe uden problemer med et minimum af vedlige-
holdelse. Ved at rengøre maskinen regelmæssigt og behandle den korrekt, bidrager De til
en længere levetid for maskinen.
Rengøring
Rengør regelmæssigt maskinkappen med en blød klud, helst efter hvert brug.
76
Hastighed
6
1
3
1
Hastighed
2
2
Hastighed
Max
3
6
1
Hastighed
5
3
5
Ferm
Read instructions carefully
In accordance with essential applicable safety standards of European directi-
ves
Class II machine - Double insulation - You don't need any earthed plug.
Denotes risk of personal injury, loss of life or damage to the tool in case of
non-observance of the instructions in this manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the mains electricity in the case that the cord
gets damaged and during maintenance
The number of revolution of the machine can be electronically set.
Faulty and/or discarded electrical or electronic apparatus have to be collected
at the appropriate recycling locations.
Special safety instructions
•
Always keep the cord away from the moving parts of the machine.
•
In the case of locking, switch the machine off immediately and remove the plug from
the mains.
•
Compare the maximum number of revolutions allowed of the accessories with the
number of revolutions of the machine.
•
When you put the machine away the engine must be switched off and moving parts
must have reached a standstill.
•
Never attach an assembly spanner to your machine with a piece of string or anything
similar.
•
Never use the axle locking button if the machine is operating.
•
Make sure that the spring chuck diameter is the same as the axle diameter of the
accessory.
•
Use a clamping device for securing the work piece.
•
Keep your hands away from the work piece.
Electrical safety
When using electric machines always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following
safety instructions and also the enclosed safety instructions. Keep these instructions in a
safe place!
Ferm
GB
05
Werbung
Kapitel
