Connecting The Appliance; Switching On The Appliance; Selecting The Temperature - Bosch KTL series Gebrauchsanleitung

en
Connecting the
appliance
After installing the appliance, wait at least.
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Do not operate the appliance until it has
been installed.
Connect the appliance to 220 240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on the
rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The power cord may be replaced by
an electrician only.
20
Switching on the
appliance
Rotate the temperature selector Fig. 2/B
from position 0". The appliance starts
refrigerating. Interior light is switched on
when the door is open.

Selecting the temperature

We recommend a medium setting
of +4 °C.
Perishable food should not be stored
warmer than +4 °C.
Rotate temperature selector, Fig. 2/B,
to a setting. Higher settings denote lower
temperatures in the refrigerator and
freezer compartments.
We recommend:
S for short term storage of food in the
freezer compartment: low setting
(energy saving mode, e.g. 1 2)
S for long term storage of food and for
freezing fresh food: medium setting
(e.g. 2 3)
S select a higher setting (e.g. 4 5) only
temporarily, if: high ambient
temperature, door opened frequently,
large amounts of food placed in the
refrigerator compartment.