Deleting Transmitters - Becker Centronic VarioControl VC 120 Betriebsanleitung

Press the STOP button and, within 3 seconds, also press the travel
button assigned to the intermediate position and hold the two but‐
tons down.
[ The shading solution shifts to confirm.
Æ The intermediate position is now deleted.
Deleting individual transmitters
Note
The programmed master transmitter cannot be de‐
leted. It can only be overwritten (see Programming
the master transmitter).
Press the programming button on the master transmitter for 3 sec‐
onds.
[ The shading solution shifts to confirm.
Now press the programming button of the transmitter to be deleted
for 3 seconds.
[ The shading solution shifts to confirm.
Then re-press the programming button of the transmitter to be de‐
leted for 10 seconds.
[ The shading solution shifts to confirm.
Æ The transmitter is now deleted from the receiver.
Deleting all transmitters (except the master trans‐
mitter)
Press the programming button on the master transmitter for 3 sec‐
onds.
[ The shading solution shifts to confirm.
Re-press the programming button on the master transmitter for 3
seconds.

Deleting transmitters

en
29