Overwriting The Master - Becker Centronic VarioControl VC 120 Betriebsanleitung

Assembly and Operating Instructions
[ The shading solution shifts to confirm.
Re-press the programming button on the master transmitter for 10
seconds.
[ The shading solution shifts to confirm.
Æ All transmitters (except the master transmitter) are now deleted
from the receiver.
1. Switch off the VC120 power for 10 seconds, then switch it back
on.
[ The receiver goes into the programming mode for 3 minutes.
Note
To ensure that the new master transmitter is pro‐
grammed in the desired receiver only, all other re‐
ceivers which are connected to the same power sup‐
ply must be deactivated from the programming
mode.
To do so, after switching back on the power, execute
a drive or stop command using the transmitter for
the given receivers.
2. Now press the programming button of the new master transmitter
for 10 seconds.
[ The shading solution shifts to confirm.
Æ The new master transmitter is now programmed and the old
master transmitter overwritten.
30

Overwriting the master