Intended Use - Becker Centronic VarioControl VC 120 Betriebsanleitung

Assembly and Operating Instructions
The VC120 must only be used to control roller shutter systems. The
VC120 is only compatible with tubular drives with plug-in connecting
cables (C-plug).
▪ Please note that radio-controlled systems may not be used in
areas with a high risk of interference (e.g., hospitals, airports).
▪ The remote control is intended solely for use with equipment and
systems in which malfunctions in the hand-held transmitter or re‐
ceiver would not pose any risk to persons, animals or property, or
which contain safety devices to eliminate such risks.
▪ The operator is not protected from interference from other tele‐
communications systems and terminal equipment (e.g., even from
radio-controlled systems which are properly operated in the same
frequency range).
▪ Only connect radio receivers to devices and systems approved by
the manufacturer.
Note
Ensure that the control unit is not installed or op‐
▪
erated close to metal surfaces or magnetic
fields.
Radio-controlled systems transmitting on the
▪
same frequency may cause reception interfer‐
ence.
Note that the range of the radio signal is limited
▪
by legislation as well as by design.
22

Intended use