Deleting Transmitters - Becker Centronic VarioControl VC320 Montage- Und Betriebsanleitung

3c) Deleting the ventilation position
Open/close the shading solution to the ventilation position.
Press the STOP button and, within 3 seconds, also press the UP button and
hold the two buttons down.
▻ The sun protection shifts to confirm.
► The ventilation position is now deleted.
Deleting individual transmitters
The programmed master transmitter cannot be deleted. It
can only be overwritten.
Press the programming button on the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Now press the programming button of the transmitter to be deleted for 3
seconds.
▻ The sun protection shifts to confirm.
Then re-press the programming button of the transmitter to be deleted for 10
seconds.
▻ The sun protection shifts to confirm.
► The transmitter is now deleted from the radio receiver.
26 - en

Deleting transmitters