WolfVision VZ-3 Bedienungsanleitung Seite 10

External Input - EXTERN
A computer can be connected to the External RGB input (#7) of the Visualizer.
By pressing the EXTERN-key (#10)
external input to be displayed to the audience.
The settings of the Visualizer can be changed in the on-screen menu (see page 10).
Use supplied cable without choke (ferrit core), other cables may block the hinge mechanically.
The Visualizer has a built-in A/D-converter in order to digitize the analog RGB signal from the computer and
output it on the RGB and DVI outputs in the selected signal format.
Supported resolutions from VGA (640x480@60Hz) to WXGA+ (1440x900@60Hz) with several resolutions
and refresh rates in this range.
Following data are provided:
Plug & Play Monitor VESA DDC
Monitor name: "WolfVision"
Video Input Definition: Analog at 0.7Vpp and separated synchronization signals
Vertical range limits: 48Hz - 86Hz
Horizontal range limits: 30kHz - 121kHz
Maximum pixel clock: 170MHz
Gamma: 2.2
Preferred resolution: SXGA- (1280x960) @60Hz
5 1
15
11
15-pin D-Sub HD
connector female
(front side, unit)
Built-in Digital Scaler for Extern-In
The Visualizer has a built-in digital image scaler which can process the signal from the external input and
output it in the same mode as the Visualizer image (For example: If the Visualizer is set to output an SXGA-
image to the projector and the computer outputs an XGA signal, the scaler of the Visualizer converts the
XGA image of the computer to SXGA-. As a result the projector does not readjust the input mode when
switching between the Visualizer and computer image).
The output resolution of the Visualizer can be changed in the on-screen menu (see page 10).
you can switch between the Visualizer image and the image of the
1 - Analog Red video
2 - Analog Green video
3 - Analog Blue video
4 - N/C Not connected
5 - GND Ground
9
6 - Red return
7 - Green return
8 - Blue return
9 - SENSE +5 V DC from Visualizer
10 - GND Ground (VSync, DDC)
11 - N/C Not connected
12 - SDA I²C data
13 - HSync Horizontal sync
14 - VSync Vertical sync
15 - SCL I²C clock