Specifications - Makita 6822 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Locking sleeve
2-1. Approximately 1 mm
2-2. Locator
3-1. Approximately 1 mm
3-2. Locator
4-1. Speed control screw

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
4-2. Switch trigger
4-3. Lock button
4-4. Low
4-5. High
5-1. Reversing switch lever
6-1. Locator
Model
Self drilling screw
Drywall screw
Bit shank size
-1
)
Overall length
Net weight
Safety class
) : 79 dB(A)
pA
2
) : 2.5 m/s or less
h
2
ENE033-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-2
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG905-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG900-1
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Drywall Screwdriver
Model No./ Type: 6822
are of series production and
3
6-2. Locking sleeve
7-1. Locator
7-2. Bit
7-3. Magnetic bit holder
6822
6 mm
5 mm
1/4" Hex
0 - 4,000
258 mm
1.4 kg
/II
Corporation as the
ENG901-1
ENH101-15
responsible