How The Visualizer Works; Installation - WolfVision VZ-C11 Bedienungsanleitung

HOW THE VISUALIZER WORKS

b
a
g
BASIC PREPARATIONS
1. Connect the power cable to the unit (#28) and plug it in.
2. If you would like to use a control monitor, connect it to the
following outputs:
Computer monitors:Preview RGB output (#32)
Video monitors:Y/C (S-Video) output (#36) or
Composite Video output (#37).
3. Connect a large viewing monitor or a projector to one of
the outputs of the Visualizer.
For choosing the right output - see page 12 and 13!
4. Turn the main power switch (#26) on the unit to "I"
(The status-LED indicates that power is supplied).
5. Press the POWER-key (#23) on the remote control. The Visualizer now runs the "power-on preset"
(automatic focusing of an DIN A5 format on the working surface, pick-up size depends on mounting
height of the Visualizer) during which the green LED light (#26) is flashing. As soon as the green
LED light stays illuminated, you can start working with the Visualizer. (The behaviour of the unit
once that power is supplied to the unit or after the POWER-key is pressed can be changed in the
unit's on-screen menu (see page 9).

INSTALLATION

When the unit is turned on for the first time, the Height Adjustment starts automatically. The Ceiling
Visualizer is pre-set to a distance of 2 m (78.76"). In most installations the installation height will be
different to this, so the following adjustments must be performed:
1. Adjustment of camera and light focus
2. Alignment of lightfield and camera field
NOTE: This is a one time setup, which must only be performed again if the distance between the
Visualizer and table is changed! - more details in the installation manual
f
e
c
d
a) light projector
b) camera
c) image path
d) light path
e) mirror light (motorized)
f) mirror camera
g) pickup area /
synchronized
lightfield
A light projector (a) inside the unit projects a
lightfield (g) the same size as the pick-up area of
the built-in camera via the mirror (e) onto the
working surface. The image is recorded by the
camera (b) using the same path via the mirror (f).
The lenses of the light projector (a) and the
camera (b) are synchronized. Thus the size of the
light field on the working surface changes when the
user changes the zoom range of the camera.
This scanning and illumination system is a
worldwide patent from WolfVision.
3
MEMORY
22
HELP
21
POWER
MENU
19 23