WolfVision VZ-C11 Bedienungsanleitung Seite 10

USB-PORT
The WolfVision USB-software can be found on the supplied CD-ROM. Please check our Internet
homepage at: www.wolfvision.com/support if an update of this software is available as a free-
download.
The software works under Windows 98/ME/2000/XP and MAC OS10 (or later).
EXTERNAL INPUT / SCALER
A computer can be connected to the External RGB input (#34) of the Visualizer.
By pressing the EXT/INT-key (#24), you can switch between the Visualizer image and the image of the
external input to be displayed to the audience.
The external mode can also be used for only one output. The behavior can be changed in the on-
screen menu (see below). The Ceiling Visualizer has a built-in scaler (A/D-converter) in order to digitize
the analog RGB signal from the computer and output it on all outputs in the selected format (allowed
signals: from VGA to SXGA/75Hz). As the built-in scaler allows the image from the external input to be
output on the PAL/NTSC video outputs, the Ceiling Visualizer can also be used as a computer to video
image converter.
External Infrared (IR) Sensor
In some rooms the 3 built-in infrared receivers of the Ceiling Visualizer may not be enough. In this case
connect the supplied external infrared receiver to the IR-sensor plug (#39) and position the IR-sensor
somewhere on the ceiling (or in the room) where the users normally point the remote control at.
ON-SCREEN MENU / ON-SCREEN HELP
For standard use of the WolfVision Visualizer it is not necessary to enter the on-screen
menu of the Visualizer and change settings. Inexperienced users should not make any
adjustments here.
To enter the on-screen menu press the MENU-key (#19) for one second. Settings of the Visualizer's
basic functions and the built-in camera can be made here using the 4 select keys (= the numerical keys
with red arrows on the remote control - #22).
Please note that some basic settings in the menu can only be changed if you set the menu item
"Format protect" to "OFF" first.
If more information on a function in the on-screen menu is required just set the cursor in the respective
line and press the HELP-key (Number 5 key #21, this key has a double function). A detailed description
of this function appears on the screen. If you want to reset the selected item to the default setting, just
press the HELP-key (Number 5 key #21) for 2 seconds!
The functions of the on-screen menu are not described in detail in this user manual as the help menu is
an integrated part of the Visualizer's software (firmware). The information you see on your screen
always belongs to the current Visualizer firmware.
HI-SPEED
CERTIFIED
TM
The USB 2.0 output of the Ceiling Visualizer can be
used to capture and transfer Visualizer images onto a
computer.
In this way the Visualizer can be used as a 3-D
scanner for your computer. Just connect the USB port
(#30) of the Visualizer and the USB port of your
computer, using the supplied USB cable. The software
is twain compatible. The USB 2.0 output is also
compatible with USB 1.1 (less speed with USB 1.1).
9
EXT/INT
24
IMPORTANT
19