Card Settings - Honeywell 026840.29 Anleitung

Mounting and Connection Instructions - Ethernet-Interface 026840.29

6.2 Card settings

1. Start the setup access via "Telnet <IP-address> <space> 9999
IP-address <space> 9999
2. Select "1 Channel 1 configuration" and check the following parameters. If necessary set them
to the values as follow (confirm both, correct and changed values with "Enter)":
Baudrate (19200) ?
I/F Mode (4C) ?
Flow (00) ?
Port No (30001) ?
ConnectMode (CC) ?
Datagram Type (01) ?
Remote IP Address: (000) .(000) .(000) .(000)
Remote Port (30002) ?
Pack Cntrl (00) ?
SendChar 1 (00) ?
Send Char 2 (00) ?
Do not change all the remaining settings!
Wrong or incorrect entries - especially a wrong Netmask
configuration - can cause the access to this ethernet interface no
longer being possible. In that case the interface must be sent back
to the manufactorer.
Baudrate: ACS-2/8 19200 oder 38400
all other devices 19200
Port No.: =
virtual EP-address of the
controller/terminal (MVA in
NetEdit) + 30000
Remote Port = virtual EP-adress of
host (MVA of the
computer in NetEdit) +
30000
33