Herunterladen Inhalt Inhalt Diese Seite drucken

The Further Configuration - Honeywell 026840.29 Anleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Mounting and Connection Instructions - Ethernet-Interface 026840.29
Connection to 01.255.03.01... P
After confirming with Enter, this message message must appear within 5 seconds.

4.2 The further configuration

1. Telnet Autoconfiguration
From IQ NetEdit / IQ MultiAccess Version 2 or higher the further configuration of the
interface card can be done automatically by selecting the menu item
Autoconfiguration
installation instructions of IQ MultiAccess (P32205-26-0G0-01ff).
In this case the card configuration is finished. The corresponding controller/terminal must
be set to the protocol
protocoll for connection directly via workstation.
These settings depend on the individual device and can be done via DIP-switches or Setup.
For further information please refer to the mounting and installation instructions of the
individual devices.
2. Manual configuration
If the Telnet Autoconfiguration option is not available, the further configuration of the card
inclusive the settings for the protocol used (chapter 5 and 6) have to be done manually as
descibed below:
1. Access to Setup using "Telnet <IP-address> <space> 9999
2. The password required is:
The first digit of the password has to be entered within 5 seconds.
3. After the input of the password and confirmation with "Enter", once again the
"Enter"-key has to be pressed within 5 seconds. If "Enter" will not be pressed within
the timeout period, the steps 1 and 2 have to be repeated.
ort 1 is u
nable to connect to host : Connection unsuccessful
of the corresponding controller/terminal. For futher information see the
used
. (DIN-protocol for connection via COM-Port-Server, Event-
01.255.03.01
IP-address <space> 9999
n5Le
(Consider capitalization and use of small letters)
25
Telnet

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis