General; Devices Supporting The Ethernet-Interface; Types Of Ethernet-Connection Cables; Assembly Diagram - Honeywell 026840.29 Anleitung

Mounting and Connection Instructions - Ethernet-Interface 026840.29

2. General

2.1 Devices supporting the Ethernet-Interface

At this time the Ethernet-interface is supported by the devices that follow:
Using DIN protocol:
external bus controller
without any restrictions.
Using Event protocol
ACS-2 / 2 plus / 8 from firmware version 5 on
For installing the Ethernet interface into the individual devices as well as for the
device specific procedure of commissioning (jumpers, setup etc.) we refer to the
manuals of the corresponding devices.
2.2 Types of Ethernet connection cables
A cable type called
has to be used.
Designations as a standard are for example:
SUTP = Screened Unshielded Twisted Pair.
2.3 Assembly diagram of the Ethernet-Interface
Mounting hole
ACS-2 / 2 plus / 8
ACT
Ethernet 10/100BASE-T Twisted Pair, category 5
1 2 3 4 5
left LED
right LED
TRS 8
TRS 15
TRS 35
TRS 8 from firmware version 5 on
TRS 15 from firmware version 6 on
TRS 35 from firmware version 2 on
CB-SUTP-; Cat. 5 E, FTP; Cat 5 E, SFTP..
LED 1: green RTS (out)
LED 2: red without function (in)
LED 3: red CTS (in)
LED 4: green TxD (out)
LED 5: red RxD (in)
21