Activate A Handset (Power On); Out Of Range; Empty Battery; Handset Lock - Topcom Butler 575C Bedienungsanleitung

Butler 575C

5.8 Activate a handset (power on)

• The handset can be activated/deactivated by pressing the Power
button.
• When you activate a handset, you will hear a warning signal.
The handset is looking for the base station.

5.9 Out of Range

• When the handset is out of the working range of the base unit or
when it's not subscribed to the base unit, it will emit a warning tone.
• You have to move closer towards the base unit or you have to
subscribe the handset to the base unit.

5.10 Empty Battery

• When the battery is almost empty, you will hear a warning tone.
• The battery symbol is shown on the display.

5.11 Handset Lock

When the handset is locked, outgoing calls are no longer possible. Incoming calls can still be
received without any problem.
• If you want to lock a handset, press and hold the Lock button for
1 second.
• To deactivate the handset lock, press the Lock button briefly.

5.12 CLIP Function

When the unit receives a phone call, the caller's phone number is shown on the handset's display.
This function depends on the base to which the handset has been registered. When the base unit
doesn't recognize CLIP-information, the telephone number will not be shown on the display.

5.13 Memory numbers

The handset is capable of storing 10 telephone numbers in the memory.

5.13.1 Programming memory numbers

A memory number can be programmed as follows:
• Enter the phone number.
• Press the Memory button. The letter "M" is added to the end of
the number in the display.
• Enter the desired memory location, for ex. 9.
• Two seconds later the telephone number appears on the display
again for 15 seconds to confirm.
• The unit returns to idle mode.
38
SEARCHING FP
RANGE OUT
MULTI 1
LOCK
091120010M
MEM 9
091120010
MULTI 1