External Call Transfer; Pause; Call Duration; Mute - Topcom Butler 575C Bedienungsanleitung

Butler 575C
• When the called handset starts to ring, the Hookswitch button will be pressed to answer the
incoming internal call.
• Press the Hookswitch button when you want to terminate the internal call.
Note : When a handset is in communication with another handset, you will hear a busy tone when
you try to reach one of these handsets.

5.3 External Call Transfer

When you are in communication with an external caller and you want to transfer this external call
to another internal handset, take the following steps :
• Press the [INT] button, followed by the number of the desired handset.
• As soon as the called handset starts to ring, the Hookswitch will be pressed. Both handsets are
now connected.
• The first handset will connect the external call to the second handset by pressing the Hookswitch.
If the second handset doesn't answer, press the [INT] button again and the first handset will be
connected to the external call again.

5.4 Pause

While entering a phone number you can add a pause to this number by pressing the Pause button
[R/P]. It should not be the first digit of a telephone number otherwise the Pause button will be
interpreted as a Redial button.

5.5 Call Duration

During and after an external call, the call duration is shown on the display.
• After picking up the handset, the call duration appears after 10 sec.
• When the call is finished, the call duration will be visible for another
2 seconds. The time is displayed in the following format: [mm : ss]
(minutes : seconds).

5.6 Mute

It is possible to deactivate the microphone during a conversation. Now you can talk freely without
being heard by your correspondent.
• Press and hold the Mute button for 1 second during a conversation.
• "MUTED" is shown on the display.
• When you want to continue the conversation, press the Mute button
a g a i n .

5.7 Paging

To find one or more lost handsets, press the Paging button on the base unit.
• All subscribed handsets will emit a signal and "BASE->PAGING" is
shown on the display.
• When you have retrieved the handset, press the Hookswitch button
to turn off the signal. Paging a handset is not possible when the
unit is in communication or is receiving a phone call.
37
23:45
MUTED
BASE --> PAGING