Intercom Operation (Intercom) - Louis Z-Link 2.0 Bedienungsanleitung

Intercom operation

7. Intercom operation (intercom)

Once two Z-Link devices have been paired, rider-to-pillion or rider-to-rider
communication can take place.
1. Switch on both Z-Link Bluetooth systems. Press the on/off button on
both control units for approx. five seconds. An audible signal sounds and
the blue LED lights up.
2. Then press the "+" and "-" buttons at the same time on both Z-Link
control units for approx. five seconds until the red and blue LEDs light up
alternately. The devices are now in pairing mode.
3. Now press and release the on/off button on one of the two Z-Link devices
(this automatically becomes the master). You will hear an audible
signal, which is repeated 2-3 times. The two Z-Link systems now connect
with one another automatically.
Note:
Once pairing is complete, the Z-Link LED lights up blue. If connecting takes
longer than two minutes and the blue and red LEDs continue to light up, it
means a connection could not be established and you will have to repeat steps
1-3. Once you have paired the devices successfully, you do not have to repeat
this process. The two Z-Link devices will now detect each other automatically
after switch on.
Operating in intercom mode
1. Ending the intercom function
Press and release the on/off button; you will hear an audible signal
from the two Z-Link devices coupled to one another.
2. Starting the intercom function
Press the on/off button for approx. two seconds; you will hear an
audible signal from the master Z-Link and two audible signals from
the slave Z-Link device. The intercom starts automatically.
Note:
Master/slave – are general names/terms for Bluetooth systems. The master
controls the communication whereas the slave is just a participant.
38