Logging On And Logging Off Handsets; Logging On Handsets; Logging On Other Dect-Gap Telephones To The Base Station - switel BDT700 Bedienungsanleitung

9.3

Logging on and logging off handsets

9.3.1

Logging on handsets

1. Press and hold the page button
two signal tones. Now log on the new handset to the base station within 90 seconds.
2. Press the
3. Select the REGISTER menu with
4. Select the REG BASE menu with
5. Now enter the number of the base station (1 - 4) using the number pad. If the handset
is already connected to a base station, the corresponding numbers will flash.
6. Confirm your entry with the
station.
7. After the base station has been found, you must enter the PIN Code for the base
station (factory setting 0 0 0 0).
8. Confirm your entry with the
tone. The handset is now logged on and can be used for external and internal calls.
9. An internal number will now be automatically assigned to the handset. The handset
that has already been logged on has the internal number 1. The second handset to be
logged on is given the internal number 2. These internal numbers are shown in the
right of the display next to the name.
9.3.2

Logging on other DECT-GAP telephones to the base station

In order to log on a DECT-GAP handset, follow the instructions in the other supplier's
operating manual and then press the
PIN-Code 0 0 0 0 to log on.
126
- Multiple handsets -
button on the handset.
button. A search will now be carried out for the base
button and after a few seconds you will hear a signal
on the base station for 6 seconds until you hear
and and confirm with
and and confirm with
button on the base station for 6 seconds. Use the
.
.