Charging Usb Device(S); Monitoring The Charging Process; Maintenance And Cleaning - VOLTCRAFT UCT 100-6 Bedienungsanleitung

INT. Voltage
12.56V
To display the voltage of individaul cells
To monitor the voltage of each individual cells, press "INC".
This function only works when you are operating on lithium batteries with balancer connections.
Example of a 4-cell LiPo battery:
C1:3.80 C2:3.80V
C3:3.80 C4:3.80V

19. CHARGING USB DEVICE(S)

You can charge up to two USB devices with this charger.
1. Power on the charger and connect up to two USB devices to the USB charging sockets.
2. Check your USB devices for the charging status.
The total current consumption of the USB devices connected at anytime must not be
higher than 1A.

20. MONITORING THE CHARGING PROCESS

You can monitor the charging process by installing the Charger Monitor to your computer.
For details on the installation, connection and operation of the software, please refer to
the supplier's manual included in the software CD.

21. MAINTENANCE AND CLEANING

The product does not require any maintenance. You should never take it apart.
The product should only be repaired by a specialist or specialist workshop or it might be damaged.
Clean the product only with a soft, clean and fuzz-free cloth. Do not use cleaning agents as they may
corrode the plastic housing and wear off the labelling.
Dust can be removed using a clean, soft brush and a vacuum cleaner.
The input voltage of the charger
C5:0.00 C6:0.00V
67