C) Cycle Program ("Cycle") - VOLTCRAFT UCT 100-6 Bedienungsanleitung

When setting the voltage value, make sure that the cell voltage for NiMH may
not be below 1.0V, with NiCd not below 0.85V. Otherwise the battery may be
damaged!
5. To begin the discharge process, keep the "Start/Enter" button pressed (approx. 3 seconds).
Now the display shows different information just like during the charge process (discharge time,
discharge capacity, discharge current and current battery voltage).
6. If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the
appropriate information is shown on the display. You can stop the audio signal by pressing the
"Batt Type/Stop" button. You then return to the previous configuration menu.
7. If you press the button "Start/Enter" during the discharge process, the discharge current can be
changed (see above).
8. Once the discharge process has been completed, an audio signal is emitted.
If you wish to terminate the discharge process beforehand, press the „Batt Type/Stop"
button.

c) Cycle program ("CYCLE")

To test or refresh batteries, you can perform up to 5 cycles in sequence. The two possible combinations
are "Charge/Discharge" ("CHG>DCHG") and "Discharge/Charge" ("DCHG>CHG").
1. After you have selected the "NiMH" or "NiCd" program in the main menu with the button "Batt Type/
Stop" and confirmed this with the button "Start/Enter", you can select the cycle program using the
button "INC" or "DEC" (illustration shows NiMH battery):
NiMH CYCLE
CHG>DCHG
2. If you want to switch the charge/discharge sequence or set the cycle number, press the button
"Start/Enter". The text for the sequence now blinks in the bottom line of the display.
Change it using the buttons "INC" and "DEC".
NiMH CYCLE
CHG>DCHG
First the battery is charged and then discharged in the left image. In the right image, this sequence
is reversed, meaning first the battery is discharged and then charged.
3. Confirm the selection by pressing the "Start/Enter" button.
4. Afterwards the cycle count blinks, meaning how often the presently set sequence of charge/
discharge or discharge/charge operations is performed. You can set a value from 1 to 5 cycles
with the buttons "INC" or "DEC". Confirm your entry as usual with the buttons "Start/ Enter".
5. To start the cycle, keep the "Start/Enter" button pressed (approx. 3 seconds).
60
1
NiMH CYCLE
1 DCHG>CHG 1