C) Charging Batteries With Balancer Connection ("Balance") - VOLTCRAFT UCT 100-6 Bedienungsanleitung

Example:
Number of cells / Charge current / Battery voltage
Li3S 1.2A 12.59V
CHG 022:43 00682
Current charging duration
7. Once the charging process has been completed, an audio signal is emitted (if the buzzer is
enabled).
If you wish to terminate the charging process beforehand, press the „Batt Type/ Stop"
button.
Under the "Charge" mode, if you connect a balancer, the charger will make use of the balancer
connections. The cell voltages will be monitored and the charge current will be adjusted accordingly.

c) Charging batteries with balancer connection ("BALANCE")

In contrast to the simple charging mode "CHARGE", the mode "BALANCE" allows the voltage of each
individual cells to be monitored. The charge current will then be adjusted correspondingly.
Aside from the The balancer connector for the battery must also be connected to the charger, see
chapter 11. a). The remaining charging process is described in chapter 11. b).
If a multi-cell battery is connected via the balancer connections, you can switch between
the normal display and the display of the cell voltages during the charge process with
the „INC" button.
Only an battery pack with exactly the same voltage for each cell provides the maximum
performance and service life for a model airplane/vehicle.
Variations in the quality of the materials used and the internal structure of multiple-cell
LiPo battery packs mean that the cells may have different voltages once discharged.
If such a LiPo battery is charged without the use of a balancer, large differences in
the cell voltages emerge very rapidly. This not only shortens the charge life (as one
cell may give in under the voltage), but also damages the battery as a result of a total
discharge.
Charge capacity in mAh
55