Intended Use; Delivery Content; Symbol Explanation - VOLTCRAFT UCT 100-6 Bedienungsanleitung

2. INTENDED USE

The charger is used to charge NiCd + NiMH type batteries (1-15 cells), LiPo/LiIon/LiFe batteries (1-6
cells) and lead acid batteries (1-10 cells, 2V-20V). The charge current can be set between 0.1A and
5.0A depending on the connected batteries and their cell number/capacity. A balancer is integrated
into the charger for LiPo/LiIon/LiFe batteries, with balancer connector sockets for the battery located
on the side of the charger. Batteries can also be discharged; the discharge current is between 0.1 to
1.0A. A two-line illuminated LCD display and four buttons are used to control the charger.The charger
may only be connected to an AC source of 100V to 240V.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged. In addition,
improper use can cause hazards such as short circuiting, fire, electric shock etc. Read the instructions
carefully and keep them. Make this product available to third parties only together with its operating
instructions.
This product complies with the statutory national and European requirements.
Observe all safety instructions and information within this operating manual.

3. DELIVERY CONTENT

• Charger
• Set of charging cables
• AC power cable
• Temperature sensor cable
• Software CD
• Operating instructions

4. SYMBOL EXPLANATION

An exclamation mark in a triangle indicates important instructions in this
operating manual which absolutely have to be observed.
The symbol can be found when you are to be given tips and information on operation.
38