Information By The Charger - VOLTCRAFT UCT 100-6 Bedienungsanleitung

BATTERY VOL ERR
CELL CONNECT
BATTERY VOL ERR
CELL LOW VOL
TEMP OVER ERR
CONTROL FAILURE

18. INFORMATION BY THE CHARGER

To display user settings
During a charge / discharge process, you can check your user settings. Press "DEC" to switch
between the various displays. The various displays are as follows :
End Voltage
12.6V(3S)
Capacity Cut-OFF
ON 5000mAh
Safety Timer
ON
Temp Cut-Off
ON 80C 118F
Ext.Temp
Int.Temp
66
Wrong connection of the balancer cable or the pin assignment
does not match that of the charger.
The battery voltage is too low. Use storage mode to build up
the voltage first before fully charging.
Internal temperature too high. Cool down the charger and the
battery.
The charger has established that there is an internal problem.
Should this message permanently be displayed, it is possible
that the charger is defective; have it checked by a specialist
workshop or qualified technician.
The voltage of the battery at the end of charging / discharging
process
The status of the capacity cut-off function
The status of the safety timer function
200min
The status of the temperature cut-off function
Temperature measured by the internal and external
26C
temperature sensor
30C