Connecting The Reader; Address Setting; Configuring The Reader; Factory Configuration - Siemens AR6111-MX Installationsanleitung

4.3.3

Connecting the reader

4.3.4

Address setting

4.4

Configuring the reader

4.4.1

Factory configuration

Siemens Building Technologies
Fire Safety & Security Products
Connect the reader as depicted in the figure.
Fig. 3 Connecting the reader
The Clock / Data interface setting does not require an address setting for the
reader.
Configuration is carried out by means of a ConfigCard. An ISO 15693 ConfigCard,
with 4-byte block size, can be used (e.g. Infineon my-d, SFR55V10P) as
transponder.
The configuration data are stored in a specified read/write data block on the
transponder. The transponder is also provided with identifiers which enable
recognition as the ConfigCard.
Create the ConfigCards using the "ConfigCard Creation Tool ASB6201".
The factory configuration of the AR6111-MX reader is as follows:
Reads serial numbers (UID) of ISO 14443 Type A, ISO 14443 Type B and ISO
15693 transponders.
Data output: Magstripe Track II, binary (80-bit) format.
The reader configuration can be modified using a ConfigCard.
Installation
11
12.2005