Operating Instructions - Cloer 6020 Bedienungsanleitung

Operating Instructions

Positioning and connection
·
Remove all packaging materials and maybe
stickers, not the rating label.
·
Put egg boiler on a dry, non-slip and even base.
Before first use
EN
·
Kindly read these instructions carefully before
using it for the first time.
·
Clean the surface of the heating unit, the cover
and the egg carrier by means of a damp cloth.
Safety instructions for applying
the egg boiler
The appliance meets the
requirements of the applicable
EC directives.
The appliance is intended for in
door use only.
·
Fill in cold water only.
·
When filling in the water quantity keep to the
marking on the measuring cup.
ATTENTION!
During the boiling process
hot steam escapes out of the lid.
·
In operation the appliance gets hot. The lid shall
be opened via handle 1 minute after the beep
sound to avoid get burn by steam.
·
Do not switch on the appliance if no water is
filled in.
·
Do not fill in more water than MAX, with the
maximum water quantity marked on the
measuring cup by the marking „1 hart " ( =
hard).
·
The water quantities on the measuring cup are
guide numbers, smaller variances can occur
because of size, age and temperature of the eggs.
ATTENTION! There is a sharp
spike at the underside of the
measuring cup which serves as
the egg pick.
·
Avoid injuries from egg picker.
·
Decalcify the appliance regularly (s. cleaning /
decalcification).
ATTENTION!
Always unplug appliance when
not in use and before cleaning!
Starting-up
·
In this egg boiler you can boil one to three eggs
at the same time.
·
Remove the cover from the appliance.
·
You can choose between soft, medium and
26
hard eggs.
·
Ascertain the water quantity depending on – the
number of eggs and the requested hardness.
·
You can ascertain this by means of the filling
quantity marking on the measuring cup which
is integrated into the lid.
·
Fill the measured volume of water into the
device with the heating plate still cold.
·
See to it that the maximum water quantity
thereby is not exceeded as otherwise the water
is likely to boil over.
ATTENTION!
Danger of burn!
·
To avoid the eggs splitting during boiling, prick
the eggs by means of the egg pick which you
can find at the underside of the measuring cup.
·
Put eggs on the egg carrier.
·
Set lid on appliance.
·
Put power plug in power socket.
·
Switch on the appliance.
·
An audible signal appears once the eggs are
ready.
·
Switch off the appliance again.
·
Pull the power plug.
·
Remove lid carefully. To do so, take the cover at
the right and left handle.
·
Take the eggs out of the appliance and run the
eggs under cold water.
Hint: Turn the lid and place the egg holder with
the eggs on it. The lid is designed for this.
Overheating protection system
The egg boiler is provided with an overheating
protection system that in case of improper
operation protects the appliance against
damages. If the appliance is operated without
water by mistake, there appears a beep after
some seconds and the overheating safety
system turns the thermostat off. In this case, pull
the power plug and let the appliance cool off for
some minutes before operating it again.
ATTENTION!
Do not pour water on
the hot heating unit.
Temperature protection system
Apart from the automatic
protection system the egg boiler is additionally
provided with a temperature protection system.
If the overheating protection fails in case of
improper operation, the temperature protection
system separates the appliance from the current
entry. In this case you will have to bring your
egg boiler to the Cloer specialist dealer or Cloer
customer service as a repeated starting-up is
not possible any more.
Cleaning / decalcification
Calcification on the heating unit has a negative
effect on the functioning of the appliance.
This is why the appliance should be regularly
decalcified. For decalcification, add a dash of
overheating