Triggering Control; Preflash Function For Red-Eye Reduction; Multi-Zone Af Measuring Beam - Metz MECABLITZ 58 AF-1 Pentax Bedienungsanleitung

a wide aperture selected (e.g. F 2.0)! The flash unit supports high speed synchro-
nisation in P-TTL (P-TTL HSS) mode.
However, due to physical properties, the guide number and thus also the range
of the flash unit are at times considerably limited in the high-speed flash mode!
Therefore, be sure to note the maximum flash range on the LC display of the
flash unit. The high-speed flash mode is automatically activated if the shutter
speed selected on the camera - manually or automatically - is faster than the
flash sync speed.
Bear in mind that in high-speed flash mode, the guide number of the flash
unit is additionally constrained by the shutter speed: The faster the shut-
ter speed, the lower the guide number! The settings are made in the
Mode menu (see 5.1). In high-speed flash mode P-TTL-HSS, contrast and
REAR mode cannot be activated, respectively these modes are cancelled
automatically as soon as P-TTL-HSS is activated (see chapters 7.12 and
16.2).

16.5 Triggering control

The camera will prevent the flash from triggering if the available ambient light is
too bright for normal mode exposure. The exposure will be made with the shutter
speed shown on the display or in the viewfinder of the camera. With some
cameras, the trigger control is active when the flash-ready indicator on the view
finder goes out. When the camera shutter is released, no flash is fired.
On some cameras, the trigger control only works in fully automatic or program-
me "P" mode (see the camera's operating instructions).
112

17. Preflash function for red-eye reduction

The red-eye effect occurs when the person being photographed is looking more
or less straight into the camera, the ambient lighting is poor, and the flash unit is
mounted close to the camera. The flash unit then illuminates the interior of the
subject's eyes through the pupils.
Some camera models have a preflash function for reducing the red-eye effect.
One or more preflashes induce the pupils to contract more, thereby reducing the
red-eye effect.
On some cameras, the preflash function supports only the camera's inter-
nal flash unit or an illuminator incorporated in the camera body (see the
camer's operating instructions). The preflash function is set on the camera
(see the camera's operating instructions). Second curtain synchronisation
(2nd curtain) is not possible when the preflash function is used.

18. Multi-zone AF measuring beam

The multi-zone AF measuring beam
camera when the ambient lighting conditions become inadequate for automatic
focusing. It projects onto the subject a striped pattern that the camera can use to
focus. Depending on the camera's activated AF sensor, the AF beam has a range
of approximately 6 m to 9 m (with a standard 1.7/50 mm lens). The maximum
flash range is reached with the camera's central AF sensor. Parallax error bet-
ween lens and AF measuring beam limits the close-up range with the AF measu-
ring beam to approximately 0.7 m to 1 m.
If the multi-zone AF measuring beam
the „single AF (S)" autofocus mode must be set on the camera and the
flash unit must indicate flash readiness. Some camera models support
only the camera's internal AF measuring beam. In this case, the multi-
zone AF measuring beam
case of compact cameras; see the camera's operating instructions).
Low-speed zoom lenses can significantly curtail the range of the AF measuring
beam.
is activated in the flash unit by the
is to be activated by the camera,
of the flash unit is not activated (as in the