Connecting The Speakers And Antennas - Yamaha CRX-E400 Bedienungsanleitung

GETTING STARTED

Connecting the speakers and antennas

Never plug the AC power cord to the wall outlet until all connections are
completed.
Follow the steps as shown below to connect the system using the supplied cords and accessories. Be sure all connections are
made correctly, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–".
Right speaker
1
Connect the Speakers.
1 Unscrew the knob.
2 Remove approx. 10 mm (4") of insulation from
each of the speaker wires and insert the bare wire
into the terminal.
3 Tighten the knob to secure the wire.
Red: positive(+)
Black: negative(–)
2
Connect the AM Antenna.
Set up the AM loop antenna, then connect it.
GND
AM
ANT
4
3
FM antenna
2
AM loop antenna
C
IN
MD
OUT
FM ANT
D
75Ω UNBAL.
A R
IN GND
TAPE
OUT
AM
ANT
B
IN
CD
E
IN
6Ω MIN./SPEAKER
AUX
R L SPEAKERS
1
2
1
3
L
+
–
SUBWOOFER SYSTEM
CONNECTOR
OUT
4
3
Connect the FM Antenna.
4
Connect the AC power cord to a wall outlet.
Notes
• Use external FM/AM antennas if you need better reception.
Consult your dealer.
• The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
To connect the subwoofer (optional)
You can reinforce the bass frequencies by adding a
subwoofer (optional).
Connect the SUBWOOFER OUT terminal of the unit to
the INPUT terminal of the subwoofer.
Left speaker
To wall outlet
FM ANT
75 Ω UNBAL