Connecting The Power Cable - Yamaha CD-S3000 Bedienungsanleitung

Connections
■ Connecting to the BALANCED OUT
jacks
Connect your amplifier with the XLR balanced input
jacks. The pin assignments for these jacks are shown
below. Refer to the owner's manual supplied with your
amplifier and verify that its XLR balanced input jacks are
compatible with the pin assignments.
1: ground
3: cold
When connecting, be sure to match the pins and insert the
connector of the "female" XLR balanced cable. When
disconnecting, pull out the "female" XLR balanced cable
while pressing down the latch lock on the plug.
Latch lock
"Female" XLR connector
20
En
2: hot
"Male" XLR connector

■ Connecting the power cable

Plug the power cable into the AC IN inlet when all
connections are complete, and then plug in the power
cable to the AC outlet.
USB OPTICAL COAXIAL
DIGITAL IN
TE
OUT
AC IN
to an AC outlet
OPTICAL
DIGIT
Rear panel of CD-S3000
Supplied power cable