Resetting The Unit - Pioneer S-BD500FS Bedienungsanleitung

Troubleshooting
Symptom
BD-Live feature does not
work.
Radio stations cannot be
tuned in.
Updates
Note that information on this product is available on the Pioneer website.
Please check the website for information on updating or servicing your Blu-ray
Disc PLAYER.
• Design and specifications are subject to change without notice.
Possible Cause
• External USB device is not connected.
• The connected USB device does not have enough
space.
• Internet connection is not established.
• The [BD-LIVE connection] option in the [Setup] menu
is set to [Prohibited].
• The signal strength of the stations is too weak (when
tuning in with automatic tuning).
• Connect a FAT16 or FAT32 formatted USB device to the
USB port (see page 22).
• Secure at least 1GB free space in the USB device for
using BD-Live features.
• Ensure that the unit is correctly connected to the local area
network and can access the internet (see page 19-20).
• Set the [BD-LIVE connection] option to [Permitted].
• Use direct tuning.

Resetting the unit

If you observe any of the following symptoms.
• The unit is plugged in, but the power will not turn on or off.
• The front panel display is not working.
• The unit is not operating normally.
You can reset the unit as follows.
• Press and hold the POWER button for at least five seconds. This will
force the player to power off. Press the POWER button again to turn
the player back on.
• Unplug the power cord, wait at least five seconds, and then plug it in
again.
Correction
47