Operation; Assembling The Appliance - Gastroback PRO M Bedienungsanleitung

Add onions and finely grinded spices, while mincing the foods for getting an even mix-
ture. However, hard spices (e.g. pepper, nutmeg, etc.) must be grinded in a mill, before
processing with the mincer. It is a good idea to fry onions for minced pork before pro-
cessing. This way, onions are more flavoury and wholesome.

OPERATION

WARNING: The mincer is intended for mincing food. For this, the appliance is equip-
ped with sharp-edged knives and other electrically driven moving parts. Do not insert
your hands or any foreign objects (e.g. cooking utensils) in the feed tube, or outlet of the
cutter housing while the appliance is connected to the power supply, to avoid risks of
injuries.
Always switch OFF the ON/OFF button first, then switch OFF the power switch, then
unplug the appliance, before assembling or disassembling any parts. Before operation,
always ensure that you have assembled the appliance completely and correctly accor-
ding to the instructions in this booklet, and that there are no foreign objects in the feed
tube. Carefully remove hard, uneatable parts of your foods (e.g. bones, gristle, sinews,
seeds, stalks, hard shells) completely, before mincing.
Do not place clothes, tissues or any other foreign objects on or under the appliance duri-
ng operation. Do not place the appliance over a power cord. Only use the provided
pusher with the appliance. Do not use any hard or sharp-edged objects (e.g. forks, kni-
ves), to avoid damage to the appliance. Do not cut your foods on the tray of the appli-
ance. Do not use violence!

ASSEMBLING THE APPLIANCE

WARNING: Only place the motor housing on a stable, dry, level, and clean surface.
Do not place any clothes or tissue or other foreign objects on or under the appliance
during operation, to avoid risk of fire or electric shock. Do not block the ventilation slots
at the bottom of the motor housing. The buttons for operation and the power switch must
be accessible any time, during operation.
Always ensure that the appliance is NOT connected to the power supply, before assem-
bling or disassembling the appliance.
Do not pour any liquids over or in the motor housing! Do not pour any liquids in the feed
tube with the cutter housing connected to the motor housing! Always immediately switch
OFF and unplug the appliance, if liquids are spilled on or in the appliance. Then clean
the appliance and let it dry naturally for one day. (See: Care and Cleaning)
1. Place the motor housing on a flat, stable, and moisture-resistant surface near a sui-
table wall power outlet. (See: Important Safeguards) Leave at least 10 cm of free
40