Drain Pump - Electrolux WTGL4E200 Benutzerhandbuch

13.7 Drain pump

Regularly examine the drain pump
and make sure that it is clean.
Clean the pump if:
• The appliance does not drain the water.
• The drum cannot turn.
• The appliance makes an unusual noise
because of the blockage of the drain
pump.
• The display shows an alarm code be-
cause of the problem with water drain.
To clean the drain pump:
5. Clean the dispenser recess with a
brush.
6. Put back the dispenser in the recess.
WARNING!
1. Disconnect the mains plug
from the mains socket.
2. Do not remove the filter while
the appliance operates. Do
not clean the drain pump if
the water in the appliance is
hot. The water must be cold
before you clean the drain
pump.
1. Open the drain pump door.
2. Pull the flap out to remove it.
3. Put a container below the recess of
the drain pump to collect the water
that flows out.
4. Press the two levers and pull forward
the drainage duct to let the water
flow out.
ENGLISH 25