Using The Appliance - Drying Only - Electrolux WTGL4E200 Benutzerhandbuch

• Press button
pliance. After five minutes from the end
of the programme, the energy saving
function automatically deactivates the
appliance.
When you activate the appliance
again, the display show the end of
the last set programme. Turn the
programme knob to set a new cy-
cle.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent the
creases in the laundry.

10. USING THE APPLIANCE - DRYING ONLY

WARNING!
Open the water tap. Put the drain
hose in the sink or connect to the
drain pipe.
• Load the laundry.
• Turn the programme dial to the pro-
gramme suitable for the items to dry.
To have best performances in dry-
ing when you wash the laundry
set a spin cycle at the maximum
speed allowed for your type of
items.
You can dry your laundry in two ways:
With the automatic drying:
• press the button
until a black line appears under one of
the dryness level symbol:
to deactivate the ap-
1
The drying symbol comes on.
8 again and again
Extra dry symbol
Cupboard dry symbol
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin
speed.
2.
Press the Start/Pause button
The appliance drain the water and
spin.
3. When the programme is completed
and the door lock symbol goes off,
you can open the door
4. Deactivate the appliance.
The appliance drain and spin au-
tomatically after approximately 18
hours.
Iron dry symbol
• The display shows a time value, calcu-
lated on a default load size. If the
amount of your laundry is more or less
than the default size, the appliance ad-
justs automatically the time value during
the cycle.
• Press the button
gramme.
The door locked symbol
comes on.
The drying symbol starts to
flash.
You cannot set all levels for all
type of laundry.
With the timed drying:
• Press the button
set the drying time value (see the «Pro-
gramme for timed drying» table). The
display shows a minimum time value.
Set time value
ENGLISH 19
.
4
4 to start the pro-
7 again and again to