Transport; Storage; Guarantee; Possible Faults - ATIKA BWS 500 Betriebsanleitung

Transport

Remove mains plug before each transport.
Before each transport:
1. Push the jigging device towards the saw blade and fix the transport
safety device (23). Secure it using the machine knob (22).
2. To move the machine hold the handle, place your foot on the axle
and tilt the saw slightly to your body. In this position, it is easy to move
T
the saw.

Possible faults

Before each fault elimination:
− Switch off device
− Wait unitl the saw comes to a stop.
−
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on
Jigging does not work
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging
device does not work
Decelaration too slow (time to dead stop
>10 sec.)

Technical data

Type
Motor rating P
1
Motor output P
2
Mains voltage
Mains frequency
No-load speed n
0
Mains fuse
Protection class
Saw blade ∅ maximal
Saw blade location hole ∅
Number of teeth
Thickness of splitting wedge
Cut width
Max. cutting capacity
Dimensions (length x breadth x height)
Weight (incl. accessories)
S
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Transport locking device not released
• Saw blade blunt
• Feed is too great
• Saw blade blunt
• Saw blade is warped
• Saw blade not properly mounted
• Recuperating spring broken or worn out
• Recuperating bolt popped out from its bracket
• Motor brake defective
• Brake disk worn

Storage

Pull out power plug
Store unused equipment in a dry, locked place out of the reach of children.
Before a longer period of storage carry out the following to extend the saw
service life and ensure an easy operating:
− thoroughly clean the device
− treat all movable parts with an environmentally friendly oil
Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Remove transport locking device (23)
• Replace saw blade (14)
• Allow motor to cool and proceed working with less
pressure
• Replace saw blade
• Replace saw blade
• Mount saw blade properly
• Replace the recuperating spring
• Insert the recuperating bolt in its bracket and secure it
with a cotter pin
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
BWS 500
3,0 kW S6 - 40 %
2,2 KW S6 - 40 %
230 V
50 Hz
2990 min
-1
16 A slow
IP 54
500 mm carbide tipped saw blade
30 mm
36
2,8 mm
3,8 mm
approx ∅ 180 mm
875 x 980 x 920
56,5 kg
14