Unpacking The Appliance; Using The Device - Clatronic DG 3665 Bedienungsanleitung

Unpacking the Appliance

1. Remove the packaging of the appliance.
2. Remove all packaging material such as plastic film, filler
material, cable ties and box packaging.
3. Check that all parts are in the box.
4. If the packaging content should be incomplete or if dam-
ages should be noticeable, do not operate the appliance.
Return it to the distributor immediately.
NOTE:
Dust or production residues may still be found on the
appliance. We recommend that you clean the appliance as
described under "Cleaning".
Installation and Notes on Operation
Position
Install the device near a wall socket. Choose a flat, dry,
non-slip and heat-resistant surface with sufficient clearance
to the wall or furniture.
CAUTION:
• Do not place the steamer under wall cabinets!
• The steamer and accessories are not suitable for use
in stoves (microwave, convection or conventional) or on
stovetops!
Instant Steam Function
The special steam pipe will release steam after a few
seconds. This component covers the heating element and
regulates the subsequent water flow.
IMPORTANT NOTE:
Pay attention to the correct
assembly!
Put the steam tube with the wide
side and the small notch facing
down over the heating element.
Filling with Water
NOTE:
• Note the markings MIN (Minimum) and MAX (Maximum).
• Fill the water reservoir with clear and clean water only.
Do not put any other liquids or add any salt, pepper, etc.
in the water reservoir.
• The water level indicator shows the water level in the
water reservoir.
• Fill the reservoir till the maximum level (1.5 liter).
• When steaming longer than 15 min., always fill the reser-
voir till the maximum level.
Condensation Collection Tray
Place the collection tray with the recess facing in the direction
of the timer in the base unit. The collection tray must sit flush
with the base unit.
42
DG3665_IM
Using One Steam Bowl
NOTE:
• In order to simplify the use, the bowls are marked with
1, 2 and 3.
• Only the steam bowl marked "1" fits on the collection tray.
1. Place steam bowl "1" on top of the collection tray.
2. Place vegetables, fish or other foods without sauce or
liquids into the steam bowl. Do not completely cover the
steam openings!
3. Cover the upper bowl with the lid.
Using Two or Three Steam Bowls
1. Place steam bowl "1" on top of the collection tray.
2. Place the biggest piece of food with the longest cooking
time into the lower steam bowl.
3. Place steam bowl "2" on top of steam bowl "1".
4. Place the desired food into the bowl.
5. Place steam bowl "3" on top of steam bowl "2".
6. Place the desired food into the bowl.
7. Cover the upper bowl with the lid.
Using the Rice Bowl
1. Put rice or other foods with sauce or liquid in the rice
bowl.
2. Place the rice bowl into a steam bowl.
3. Finally, put the lid on.
NOTE:
Please continue observing our "Cooking instructions".
There you will find suggestions on water quantities for
different rice grades.
Mains Connection
1. Check if the mains voltage that you want to use matches
that of the appliance. You will find the information about
this on the type plate of the basic unit.
2. Make sure the timer is switched off.
3. Connect the device to a properly installed isolated ground
receptacle.

Using the Device

• After filling with water, first place the collection tray and
then the steam bowls and the lid.
• Position the lid with the steam opening on the back.
• Do not cover the steam openings during operation. Allow
the steam to escape unhampered.
Switching On
Use the timer switch to set the desired cooking time. Please
observe our "Cooking instructions". The control lamp indi-
cates the operating mode.
01.09.16