Troubleshooting - Waves Robot stofzuiger RVC-104691 Bedienungsanleitung

Clean Side Brushes
1. Turn off the power, place bottom of the cleaner upward on a flat surface. Hold the brush hair
and pull upward to remove the brush and then clean up the hair or other matters by hand.
(Please refer to page 12 as shown in Fig.5)
2. Install the lids and brushes after finishing. After being used for a period of time, the brushes
need to be replaced more effectively.
3. The side brushes can be rinsed and if they become crooked, you can scald them in hot water
to make them return to original shape.
Remove Removable Back Sensor Switch
*Pull up the switch as shown in Fig.22.
TROUBLE SHOOTING
PROBLEM
Red LED flashes after turn on
the power switch.
Turn on the power switch
with no indication lamp on.
The unit moves only in
circular motion.
Remote control
work.
Can't use remote to control
the unit while it is in docking
station.
PROBABLE CAUSE
Low battery.
1. Battery is not installed
correctly. 2. Very low battery.
The wire between wheel set
and the unit is loosened.
doesn't 1. The batteries for the
remote control are exhausted.
2. The "AAA" batteries are not
installed correctly or not
installed.
The power switch of the unit
is not on.
SOLUTION
Charge the unit.
1. Install the battery acc‐
ording to the manual. 2.
Charge the battery according
to the manual
Contact the service dept. for
repair.
1. Change a new set of
batteries. 2. Re‐install the
batteries correctly.
Turn on the power switch.