1 .Press the "AUTO" on the remote control or press "FUNCTION" on the unit ("FUNCTION" will
work only when the unit is not contacted with the docking station) to select the work time: "60"
or " 30 ". Please refer to table 2.
2 .After 2 seconds, the unit begins cleaning automatically.
3 .After the work is completed, the unit will emit a buzz of warning and stop or return to the
docking station depend on the function selected (please refer to table 1). If the power indication
lamp turns to Red flashing (battery low) at the same time, the unit will emit a buzz every minute
till you switch off power switch, battery exhausted or returned to the docking station.
Schedule work
1. Set up the schedule according to the manual of control panel of docking station. (Please refer
to page 9.)
2 .The unit will work according to the schedule set.
Stop operation
1 .To stop the operation of the unit immediately, you can turn off the power switch on the right
of the unit, lift the unit off the floor, the unit will stop after 3 seconds or press the " STOP " on
the remote control.
2. If you want the unit continue to work, place the unit on the floor and press "AUTO" button on
the remote control.
Safety Devices
1. The unit will STOP when lifted up from the floor.
2 .The unit will STOP when wheels jammed for more than 10 seconds.
3. Adjustable anti‐cliff sensors (please refer to P.5). The windows are adjustable according to the
height of the step and the color of the floor. The windows have four stages:"3" "2" "1" "0". The
factory setting is "1". The smaller the number is, the shorter distance can be detected.
Owner can adjust the windows if necessary. The scale of the windows must be the same to
ensure the unit function normally.
4. Removable back sensor switch is to restrain the mobility of the unit in case the machine is
stuck, and it can be removed from or plugged onto the base according to the condition of the
environment (please refer to P.5). Recommend removing the switch if the difference of the floor
surface to be cleaned is more than 1.5cm.
ADJUSTMNET OF ANTI‐CLIFF SENSORS
There are three "Anti‐Cliff" sensors at the bottom to prevent the unit from falling down stairs. If
the distance between the stair and the ground is shorter than usual, please adjust all windows
of "Anti‐cliff" sensors to "" or "2" or "1" or "0" position to prevent the cleaner from falling down
stairs. Please test it before it starts to clean.
ATTENTION: If the color of the floor is dark (ex. Black), it means that reflectivity of the floor is
bad, at this time, you have to open the window to a larger scale. Please refer to the criteria of
adjustment for adjusting the windows.