5th Press
6th Press
7th Press
Note1: Docking function on: the unit will return to the docking station to charge the battery.
Note2: The unit will not return to the docking station after work.
3. MOP
Press "Vacuum" once on the remote control and the MOP light will be on to indicate the unit is
working with mopping mode only (without vacuum and sweeper.)
Press "Vacuum" again to reactive the vacuum and sweeper.
REMOTE CONTROL
1. Auto
2. Forward
3. Turn Left
4. Turn Right
5. Stop
6. Backward
7. Vacuum switch
8. Docking
9. Spiral
10. Random
11. Along the wall
12. "Z" type
13. IR transmitter
1. 2 "AAA" batteries required.
2. Function of buttons:
Key Pressed
Action
AUTO
Please refer to Table 2 for Pressing "AUTO" button.
FORWARD
Move forward with vacuum on and will stop when bumper encounter any
obstacle or by pressing "STOP" button.
LEFT
Turn left. Pressing and holding the button makes it turn left continuously.
RIGHT
Turn right. Pressing and holding the button makes it turn right continuously.
STOP
Stop the unit immediately.
BACKWARD
The unit going backward for 20 cm. The unit doesn't have the back anti‐cliff
sensor to prevent it from falling from stairs when moving backward.
VACUUM
Switch the vacuum power or to turn off vacuum and sweeper (with mop
function on only).
DOCKING
Search the docking station for charging.
SPIRAL
Move in spiral pattern with vacuum on until the bumper encounter an
obstacle or stairs, then the unit will continue operate in "AUTO" mode with
60 minutes working time or until battery low.
RANDOM
Operate in the random mode continuously with 60 minutes working time or
until the battery low.
"M" with yellow flashing.
"S" with green flashing
No lamp lighted
40‐minute work time with
docking function off.
20‐minute work time with
docking function off.
stop