Charging The Battery; General Operation - Waves Robot stofzuiger RVC-104691 Bedienungsanleitung

CHARGING THE BATTERY
1. Before charging, please check if the battery is properly mounted and turn on the power
switch.
2. Two ways to charge the battery: A. Make sure the docking station is installed properly, place
the unit to the docking station shown in fig.10, make sure the contact points at the back of the
of the unit is contacted with the contact plate at the docking station. B. Plug the d.c. end of the
adaptor into d.c. jack at the side of the unit first, and then plug the a.c end of the adaptor into
the a.c. power outlet on the wall. (Please connect the adaptor to the unit first before connecting
to the a.c power outlet.) Please refer Fig.11.
3. For a new battery or the battery has been idled over 3 months, the battery should be
charged for 12 hours before operation.
4. It takes at most 6~8 hours to fully charge the battery.
5. During the charging state, the power indication lamp on the control panel will flash green. 6.
The power indication lamp will stay green when the battery is fully charged.
GENERAL OPERATION
Preparation for Operation
1. Install the docking station, side brushes and battery according to the manual.
2. Turn on the power switch on the side of the unit, and charge the battery for 6~8 hours prior
to the first operation.
Basic operation
Manual work