Setting The Midi Receive Channel; Real-Time Parameter Change - Yamaha REV100 Bedienungsanleitung

MIDI Mode

Setting the MIDI Receive Channel

By default, the REV100 is set to receive MIDI on all channels (OMNI mode). You can change this default with the following pro-
cedure:
1. Press and hold the MIDI key as you switch on the power to the REV100.
The 7-segment LED will display "
2. Select another MIDI channel number by pressing the
You can select "
3. Press the MIDI key again to return to normal operational mode.

Real-time Parameter Change

You can send MIDI Control Change messages to the REV100. Some of these messages perform the same function as the front
panel Edit controls, others allow you access to additional parameters:
Effect Type
REVERB
STEREO REVERB
GATE REVERB
DELAY
DELAY/REVERB
8
" and the current MIDI channel number alternately.
" (OMNI), " " to "
Parameter Name
Pre Delay
Reverb Time
Effect Level
High Damp
Filter Type (LPF/HPF)
Cut-off Frequency
Pre Delay
Reverb Time
Effect Level
High Damp
Pre Delay
Gate Level
Effect Level
Reverb Time
High Damp
Release Time
Filter Type (LPF/HPF)
Cut-off Frequency
Delay Time
Feedback Level
Effect Level
High Damp
Filter Type (LPF/HPF)
Cut-off Frequency
Delay Time
Feedback Level
Reverb Level
Reverb Time
Reverb High Damp
Delay High Damp
Filter Type (LPF/HPF)
Cut-off Frequency
or keys.
", or " " (OFF).
Controller Number
20
21
22
23
24
25
20
21
22
23
20
21
22
23
24
25
26
27
20
21
22
23
24
25
20
21
22
23
24
25
26
27