Analog Operation - LGB 65000 Bedienungsanleitung

You can program the following registers:

Analog operation

Register Function
CV58 Starting voltage (analog operation without wheel sensor)
To adjust the sound to the loco starting settings - if sound
starts before the loco starts moving, increase value.
CV59 max. speed (analog operation without wheel sensor)
CV64 Synchronizing a wheel sensor (see Fig. 2)
If the wheel sensor is not installed on a drive axle, you can
adjust for different wheel diameters. You also can program
the number of magnets.
Digital operation with the Multi-Train System
Register Function
CV1 Loco address
CV2 Starting voltage (without wheel sensor)
To adjust the sound to the loco starting settings - if sound
starts before the loco starts moving, increase value.
CV3 Acceleration (without wheel sensor) (1 = fast, 255 = slow)
CV4 Braking (without wheel sensor) (1 = fast, 255 = slow)
CV5 Max. speed (without wheel sensor)
Voltage for highest speed step - if a "slower" sound at top
speed is desired, decrease value.
CV5 after input of CV6 (when programming with older 55015)
function value for CV to be programmed
CV6 CV to be programmed (when programming with older 55015)
CV29 Configuration
0 = normal direction
1 = reverse direction
CV55 Reset of most programmed CVs
55 = most important CVs are reset to the factory pre-set
values
CV64 Synchronizing a wheel sensor (see Fig. 2)
If the wheel sensor is not installed on a drive axle, you can
adjust for different wheel diameters. You also can program
the number of magnets.
14
Available Factory
values pre-set
(1..255) [48]
(1..255) [255]
(9..255) [82]
Available Factory
values pre-set
(00..22) [3]
(0..255) [0]
(1..255) [3]
(1..255) [3]
(1..255) [255]
[0]
(9..255) [82]